Shop by Brand

You are here: Knowledge Base > Bowl Breeze

Bowl Breeze Instructions
Last Updated 8/4/2009

Instruction to use Bowl Breeze

Place all four batteries into plastic battery carrier, align positive (+) on battery with (+) positive in battery carrier, and likewise, negative (-) with negative on battery.
To open drawer (pull away from unit), place forefinger and thumb where indentations are, gently squeeze and pull.
Line up battery carrier metal (+) male and (-) female plugs with opposite side (male) and (female) plug inside the Bowl Breeze. Just push battery carrier into the plug until it snaps in place firmly, just like a 9V battery would connect to a (male) and (female) plug. Bowl Breeze should be powered up and ready to place on toilet bowl once filters are in place.
Bowl Breeze will indicate when batteries need recharged with a “blinking” green LED on the top of the unit.

Remove plastic covering on both nano silver filter (blue) and carbon filter (black).
With drawer open or detached from Bowl Breeze, place black carbon filter on drawer shelf bottom. Next place nano silver blue filter on top of black carbon filter, they should be under plastic “ribs” and firm against back inside of drawer.
Slide drawer with filters into Bowl Breeze, gently squeeze indentations with fore finger and thumb, be sure drawer is completely closed and sealed for best results.
Max. use of filters is 3 months depending on usage. When the user detects a stronger presence of toxic gas and odor, replace filter as soon as possible.

Lift up toilet seat, Bowl Breeze can be placed left or right, which ever is desired.
Slide or pull bracket out, place over rim closes to the tank for optimum performance, push bracket toward the unit to “clamp” to the rim, until the Bowl Breeze is firm. If not firm, slide Bowl Breeze back toward tank until firm, be sure that the toilet seat spacer in not where the Bowl Breeze bracket will be when seat is down, if so adjust so spacer will not make contact with bracket for best results.
If still not firm then use extra foam pad (included) to place over top of the foam pad already on bracket, just peel off adhesive cover. (Do not place foam pad on the Bowl Breeze unit pad but rather it must be placed on “bracket pad” for optimum performance).

While conducting normal bathroom cleaning, wipe top of Bowl Breeze with a cloth or paper towel applied with your usual bathroom cleaner.
To clean bracket, simply pull or slide bracket away from Bowl Breeze till it will not slide any further out. Gentle squeeze bracket ends approximately one quarter inch (1/4 inch or 8 mm) together or toward each other, then pull bracket out or away from Bowl Breeze. Rinse under hot water and wipe with cloth or paper towel applied with usual bathroom cleaner. Reverse steps to put bracket back in unit.

Note: Do not submerge Bowl Breeze in water.
Bowl Breeze should not be in direct contact with urine.